Ford 2003 F-150 v.4 Manual do Utilizador descarregar pdf (Página 70)

Reprogramming a single HomeLink姞 button

To program a device to HomeLink威 using a HomeLink威 button previously

trained, follow these steps:

1. Press and hold the desired HomeLink威 button. Do NOT release the

button.

2. The red indicator light will begin to flash after 20 seconds. Without

releasing the HomeLink威 button, follow step 2 in the “Programming”

section.

For questions or comments, contact HomeLink威 at www.homelink.com

or 1–800–355–3515.

Gate Operator & Canadian Programming

During programming, your

hand-held transmitter may

automatically stop transmitting —

not allowing enough time for

HomeLink威 to accept the signal

from the hand-held transmitter.

After completing steps 1 and 2

outlined in the “Programming”

section, replace step 3 with the following:

Note: If programming a garage door opener or gate operator, it is

advised to unplug the device during the “cycling” process to prevent

overheating.

• Continue to press and hold the HomeLink威 button (note step 3 in the

“Programming” section) while you press and release — every two

seconds (“cycle”) your hand-held transmitter until the frequency

signal has been accepted by the HomeLink威. The red indicator light

will flash slowly and then rapidly after HomeLink威 accepts the radio

frequency signal.

• Proceed with step 4 in the “Programming” section.

Operating TravelNote姞

TravelNote威 records and stores messages for up to three minutes in total

length with simple controls. When you get an idea or remember

something important while you’re driving, you don’t have to try to

scribble it down or pull off the side of the road. All you have to do is

push a button and begin speaking.

REC DEL PLAY

Driver Controls

1 2 ... 65 66 67 68 69 70 71 72 73 74 75 ... 279 280

Sem comentários

Ford 2003 F-150 v.4 Manual do Utilizador Página 70