Ford 2003 F-150 v.4 Manual do Utilizador descarregar pdf (Página 86)

Anti-scan feature

If the wrong code has been entered 36 times, the keypad will go into an

anti-scan mode. This mode disables the keypad for one minute and the

keypad lamp will flash during this time.

The anti-scan feature will turn off after:

• one minute of keypad inactivity.

• pressing the UNLOCK

control on the remote entry transmitter.

• the ignition is turned to the ON position.

Unlocking and locking the doors using keyless entry

To unlock the driver’s door, enter the factory set 5-digit code or your

personal code. Each number must be pressed within five seconds of each

other. The interior lamps will illuminate after pressing the first control on

the keypad.

To unlock all doors, press the 3 • 4 control within five seconds.

To lock all doors, press the 7 • 8 and the 9 • 0 at the same time. You

do not need to enter the keypad code first. Note: The interior lamps

will turn off.

Activating/deactivating autolock with the keyless entry system

Before following the activation or deactivation procedures, make sure

that the anti-theft system (if equipped) is not armed, the ignition is off,

and all vehicle doors are closed.

1. Turn the ignition to the OFF position.

2. Close all vehicle doors.

3. Enter the five-digit entry code.

4. Press and hold the 7 • 8 control. While holding the 7 • 8 control,

press and hold the 3 • 4 control.

5. Release the 3 • 4 control.

6. Release the 7 • 8 control.

The horn will chirp once if autolock was deactivated or twice (one short

and one long chirp) if autolock was activated.

To re-activate autolock, repeat steps 1–6.

Locks and Security

1 2 ... 81 82 83 84 85 86 87 88 89 90 91 ... 279 280

Sem comentários

Ford 2003 F-150 v.4 Manual do Utilizador Página 86