Ford 2003 F-150 v.4 Manual do Utilizador descarregar pdf (Página 129)

7. Allow the safety belt to retract to remove any slack in the belt. It will

make a clicking noise while doing this.

8. Before placing the child in the seat, forcibly move the seat forward

and side-to-side to make sure the seat is securely held in place.

9. Check to make sure the child seat is properly secured before each

use.

Attaching child safety seats with tether straps

Most new forward-facing child safety seats include a tether strap which

goes over the back of the seat and hooks to an anchoring point. Tether

straps are available as an accessory for many older safety seats. Contact

the manufacturer of your child seat for information about ordering a

tether strap.

The passenger seats of your vehicle are equipped with built-in tether

strap anchors located behind the seats as described below.

The tether anchors in your vehicle may be straps on the seatback or an

anchor bracket on the rear edge of the seat cushion.

The rear seat of the SuperCab has three straps behind the top of the

seatback that function as both routing loops for the tether straps and

anchor loops.

The tether strap anchors in your vehicle are in the following positions

(shown from top view):

Attach the tether strap only to the appropriate tether anchor as

shown. The tether strap may not work properly if attached

somewhere other than the correct tether anchor.

Seating and Safety Restraints

129

1 2 ... 124 125 126 127 128 129 130 131 132 133 134 ... 279 280

Sem comentários

Ford 2003 F-150 v.4 Manual do Utilizador Página 129